Cut Once.
Full depth, single pass. The Collider™ X1 mounts to any standard skid steer and cuts up to 11½ inches deep in one pass — where standard blades step down a few inches at a time, the X1 makes the whole cut once and moves on.
Request a Quote
On The Job
Full depth in one pass
Standard blades only reach a few inches per pass, so deep cuts mean stepping down again and again. Our blades cut to full depth — up to 11½" — the first time through.
One operator, in the cab
Replace walk-behind sawing with a single operator protected in the cab — safer, and easier to keep on line. Watch your travel speed and let the blade work.
Simple hydraulics
Runs on standard skid steer auxiliary hydraulics with quick-connect fittings. Hook up and cut.
A machine you already own
No dedicated sawing machine to buy, haul, or maintain. If a skid steer is on the job, so is your pavement saw.
Where crews use it
The Blades
Teeth that cut, not grind
Abrasive segment blades wear through material — and themselves — as they go. Our PDC-toothed edge takes a real bite and keeps its geometry.
High torque, low RPM
Designed around skid steer hydraulics: maximum torque at low blade speed instead of the high-RPM scream of an abrasive saw.
Far longer blade life
PDC teeth hold their edge long after standard concrete blades are used up — fewer blade changes and a lower cost per foot of cut.
Dry cutting, when the job allows
Run wet for dust control, or dry where dust isn't a concern on that job — no water truck required.
Blade sizes & cut depths
| Blade diameter | Max cut depth (single pass) |
|---|---|
| 18" | 5½" |
| 22" | 7½" |
| 24" | 8½" |
| 26" | 9½" |
| 30" | 11½" |
CUT DEPTH = (BLADE Ø − 7") ÷ 2, ALLOWING FOR ARBOR AND SHROUD. CONTACT US TO MATCH A BLADE TO YOUR CUT DEPTH.